#Battery cable splice kit how to
#Battery cable splice kit plus
#Battery cable splice kit series

Be sure the conductors butt up against the centre indents of the connector. Once the cable is prepared, join the power connectors with the proper connectors and cable crimping tool. Pencil the insulation for ¾” and sand it smooth and even with electrical graded abrasive cloth.

#Battery cable splice kit plus

Remove insulation for one half of the connector length plus ¼”. Remove cable semi con to ¼” of the shielding. Remove ¾” of the braid or tape metallic shielding from each conductor plus one half the connector length plus ¼”. Match this conductor with the same colour conductor on the opposite end. Hold back the grounds and ground check conductors and temporarily tape to cable with Temflex 1700P vinyl tape. Scuff and clean 4” of the cable jacket beyond the top of the taper. Remove 12” of the cable jacket and cable fillers. Measure 14” from the cable end and fully taper down to the circle cut. Be sure not to damage the cable conductors. Circle cut the cable jacket 12” from each end.

Position cable end so that the colour rotation matches.

3 rolls 3M Scotch 130C linerless rubber self-amalgamating tape – ¾” x 30 ft.

3 rolls 3M Scotch 130C linerless rubber self-amalgamating tape – 1 ½” x 30 ft.

3 rolls 3M Scotch 13 semi electrical conductive tape.

2 CC2 Dry cable cleaning & preparation kits.

2 rolls 3M Scotch 2228 rubber mastic tape.

1 roll 3M Temflex 1700P vinyl electrical tape.

2 rolls 3M Scotch 31 heavy duty mining cable tape.

#Battery cable splice kit how to

This video by 3M Electrical shows how to splice a 15kV SHDC cable using 3M Mining Cable Splice Kit 3103 safely.ģM Mining Cable Splice Kit 3103 may be used for flexible conduit and mining jacket repairs, as well as for cable splicing and jointing mine and portable cable.ģM 3103 cable splices and joints are for use on 3-conductor mine and portable cables, type SHD-GC, MPF-GC and MPF # 6 AWG-500 kcmil 5kV, 8kV, 15kV.ģM Mining Cable Splice Kit 3103 Kit Contents

#Battery cable splice kit series

You also have the right to file a complaint to a supervisory data protection authority.A series of How-To videos for repairing, jointing and terminating cables using 3M Cold Shrink & Scotchcast products. Withdrawal of consent has no bearing on the legitimacy of processing that was performed prior to the withdrawal.Ĩ. To the extent that your personal data is processed on the grounds of your consent, you have the right to withdraw that consent. You have the right to access your personal data and request it to be corrected, deleted, or limit its processing ħ. Your personal data will be stored until you withdraw your consent to the processing of your personal data.Ħ. Providing data is voluntary, however, it is necessary to send an information bulletin.ĥ. The personal data controller has appointed a data protection officer, who can be reached via email: Your data will be processed on the basis of point (a) of Article 6(1) of Regulation of the European Parliament and of the Council (EU) 2016/679 of 27 April 2016 on the protection of individuals with regard to the processing of personal data and on the free movement of such data and the repeal of Directive 95/46/EC (hereinafter referred to as: GDPR), in order to send to the provided e-mail address, an electronic news bulletin of TME.Ĥ. Ustronna 41, 93-350 Łódź hereby informs you that it will be the controller of your personal data.Ģ.